Immersion cooling for Bitcoin mining
An immersion cooling system for mining is a tank of non-conductive fluid that the machines sit in, plus the pumps, heat exchanger and outdoor cooler that carry the heat away. This guide covers the parts, the two kinds of system, how immersion compares with hydro and air, and what decides the cost.
Published November 17, 2026. Machine figures are the manufacturers' as reported by the sources at the end.
What an immersion system is
An air-cooled miner pushes air across its hashboards with fans. In immersion, the fans come off and the whole machine is lowered into a tank of dielectric fluid, a liquid that does not conduct electricity. The fluid touches every component, takes up the heat and carries it out of the tank.
Liquid carries far more heat than air, so the same chips can run harder and closer together. Dust, humidity and fan failures stop being problems, and the room is quiet.
The parts of a system
- Tank
- Holds the machines and the fluid. Sizes run from a single-machine tank to container-length units.
- Dielectric fluid
- A non-conductive oil or engineered fluid. It has to stay clean, and it is topped up as machines are lifted in and out.
- Pump and heat exchanger
- Move the warm fluid out of the tank and pass its heat to a water loop.
- Dry cooler or cooling tower
- Releases the heat outdoors. In a heat-reuse site it goes to a building, greenhouse or process instead.
- Power distribution
- PDUs and cabling rated for the tank's full load, mounted clear of the fluid.
- Firmware and monitoring
- The machines must run without fans and report fluid and chip temperatures.
Single-phase or two-phase
- Single-phase
- The fluid stays liquid and is pumped through a heat exchanger. Widely used in Bitcoin mining.
- Two-phase
- The fluid boils on the chips and condenses on a coil above the tank. It removes heat very efficiently but needs specialised fluids and sealed tanks.
Immersion, hydro or air
- Air
- Cheapest to build and simplest to run. Loud, dusty, and limited by outside temperature.
- Hydro
- Water runs through cold plates on the hashboards in a sealed loop. Dense and quiet, and the machines arrive built for it.
- Immersion
- The whole machine is submerged. Dense, quiet and tolerant of heat and dust, with more fluid handling and a higher build cost than air.
The glossary has short entries on immersion cooling and hydro cooling. For data centers and AI racks, see Intelligence Disrupt's liquid cooling guide.
Machines built for it
- MicroBT's Whatsminer M70 series, announced December 2025, includes the M76S+ for immersion.
- Auradine's next-generation Teraflux line includes immersion versions alongside its air and hydro models.
- Block's Proto Rig is air-cooled and described as immersion-ready.
All current models are compared in the ASIC miner guide.
What decides the cost
- The build. Tanks, fluid, pumps and coolers cost more than fans and filters. Ask suppliers for a price per kilowatt of machine load.
- The fluid. The first fill is a real line item, and so is keeping it clean.
- The climate. The hotter and dustier the site, the more immersion gives back.
- The extra hashrate. Machines can be run harder in fluid. Whether that pays depends on your power price and on hashprice.
- Labour. Lifting machines out of fluid for repair is slower and messier than pulling one off a shelf.
- Warranty. Confirm what the machine maker covers once a machine has been submerged.
Braiins' breakdown of the economics, listed in the sources, walks through these trade-offs with worked numbers.
See one running
Immersion tanks, fluids and container builds are shown working on the Mining Disrupt expo floor, where you can compare suppliers side by side. See who exhibits and the mining expo page. If you plan to place immersed machines with a host, read the hosting guide first.
Questions
- What is immersion cooling in Bitcoin mining?
- Running mining machines submerged in a tank of non-conductive fluid. The fluid carries the heat away instead of air, so the machines run without fans.
- What is the difference between single-phase and two-phase immersion?
- In single-phase systems the fluid stays liquid and is pumped through a heat exchanger. In two-phase systems the fluid boils on the chips and condenses on a coil above the tank.
- Is immersion cooling worth it for mining?
- It depends on the site. Immersion costs more to build than air cooling, and pays back through higher power per machine, less dust and noise, and steadier operation in hot climates. Compare the extra build cost with the extra hashrate at your power price.
- Can any ASIC miner be immersed?
- Machines are immersed with their fans removed, and firmware has to accept that. Several makers now sell models built for immersion. Check the maker's warranty terms before submerging an air-cooled machine.
- Is immersion the same as hydro cooling?
- No. Hydro cooling runs water through cold plates fixed to the hashboards in a sealed loop. Immersion submerges the whole machine in fluid.
- Where does the heat go?
- From the fluid into a water loop through a heat exchanger, then outdoors through a dry cooler or cooling tower, or into a building or process that can use it.
More guides
Sources
- Braiins, The economics of immersion cooling · 2022-05-09
- Hashrate Index, MicroBT reveals the Whatsminer M70 series · 2025-12-08
- The Block, Auradine next-generation Teraflux · 2025-11-12
- Hashrate Index, Proto Rig review · 2025-08-14
Three days. One floor. The whole industry.
March 22–24, 2027 · Irving Convention Center · Dallas
Mining Disrupt is NOT affiliated with any other brands, groups, events, meetups, individuals, sponsors, exhibitors, agents, or referrals, except the Industry Ambassadors listed on this site. We do not sell any lists. Beware of scams claiming otherwise.
There are imitators and scammers using our name to solicit sponsors and attendees. Always verify directly through our official Telegram group. Stay vigilant!
Mining Disrupt Policy: No refunds. No outside food or drinks. No third-party event solicitations.
Unauthorized solicitation, sales, advertising, product demonstrations, or distribution of promotional materials, including magazines, brochures, flyers, catalogs, business literature, and promotional giveaways, is strictly prohibited anywhere within the event venue unless expressly authorized by Mining Disrupt.
Marketing activities are reserved exclusively for approved exhibitors, sponsors, and authorized event partners. Attendees found engaging in unauthorized promotional activities may be required to cease immediately, surrender promotional materials, and may have their event credentials revoked without refund at the sole discretion of event management.

